Skip to content
๐Ÿ  Fish

What will aquarium electricity cost me each month with a heater, a filter and a light?

Asked by BestiePaws team ยท 4 months ago

Say you’re thinking about a 20-gallon freshwater tank, or already own one, and your electric bill is tight. The heater says 100 watts, the filter is on all day, and the light is on for eight hours. You don’t know what an aquarium electricity cost really adds up to each month, whether a betta or a goldfish costs less to run, and what you can change to cut the bill without hurting the fish.

1 reply

  1. BestiePaws team Team 4 months ago

    For most home tanks, aquarium electricity cost is a few dollars to maybe fifteen dollars a month, and nearly all of it is the heater. The way to know your own number is a short calculation: watts times hours, divided by 1,000, times your price per kilowatt-hour. Below are worked examples using the U.S. average, plus the places where a tank can quietly cost more than you'd think.

    The formula and the rate

    Every device has a wattage on its label, usually on the heater's box or the small sticker on the filter and light. Multiply watts by the hours it runs in a day, divide by 1,000, and you've got kilowatt-hours a day. Multiply by 30 for a month, then by your rate.

    For the rate, the U.S. Energy Information Administration says the annual average residential price in 2025 was 17.30 cents per kilowatt-hour. EIA also notes that prices vary by locality, based on power plants, fuel costs and regulation, so check your own bill. Take the total charge and divide it by the kilowatt-hours used, and that's your real rate. The examples below use 17.30 cents, or $0.173.

    Examples, device by device

    • Heater, 50 watts, running nonstop: 50 x 24 / 1,000 = 1.2 kilowatt-hours a day, 36 a month, about $6.23.
    • Heater, 100 watts, running nonstop: 72 kilowatt-hours a month, about $12.46.
    • Heater, 25 watts, running nonstop: 18 kilowatt-hours a month, about $3.11.
    • Filter, 10 watts, around the clock: 7.2 kilowatt-hours a month, about $1.25. A 5-watt filter is about 62 cents, and a 3-watt filter about 37 cents.
    • Air pump, 4 watts, around the clock: 2.88 kilowatt-hours a month, about 50 cents.
    • LED light, 12 watts, 8 hours a day: 2.88 kilowatt-hours a month, about 50 cents.
    Advertisement

    A heater with a thermostat doesn't run nonstop. It clicks on until the water reaches its setting and off again, so the nonstop numbers are an upper limit. How much it really runs depends on your room temperature and the tank. A warm room means a few minutes of heating a day. A cold basement means much more. If you want the real figure, a plug-in electricity meter measures what the heater actually uses over a few days.

    Three sample tanks

    Say you've got a 20-gallon tropical tank with a 100-watt heater, a 10-watt filter and a 12-watt light on 8 hours a day. If the heater runs half the time, the monthly total is 36 + 7.2 + 2.88 = 46.08 kilowatt-hours, or about $7.97. If it runs nonstop, 72 + 7.2 + 2.88 = 82.08 kilowatt-hours, about $14.20. Over a year, a 100-watt heater at full tilt is 876 kilowatt-hours, about $151.55.

    A betta tank with a 25-watt heater, a 3-watt filter and a 5-watt light for 8 hours comes to at most about $3.69 a month, and about $2.14 if the heater runs half the time. A University of Illinois veterinarian says bettas need the water between 76 and 81 degrees Fahrenheit, so a heater is part of the deal.

    A goldfish tank with no heater, a 10-watt filter and a 10-watt light on 8 hours runs about 9.6 kilowatt-hours a month, around $1.66. PetMD's veterinary care sheet says goldfish do best between 65 and 75 degrees and aren't suited to tropical tanks, and Merck says goldfish and certain other temperate-water fish do fine at room temperature. That's an electricity saving built into the species.

    Where the big savings are

    • Match the fish to your room. This is the largest lever. A species that's happy at room temperature needs no heater, which removes most of the bill. A tropical fish in a cold room means a heater working hard all winter.
    • Keep the thermostat within the species' range. If the fish's safe range is 76 to 81 degrees, the heater doesn't need to be set at the top. Don't go below the range, and check with a vet or a care guide for your species first.
    • Put the light on a timer. Merck says fish need a day-night cycle, and constant light, meaning 24 hours a day, stresses them and leaves them more prone to disease. A timer protects the fish and trims the bill. LED lights use very little power, so the savings are modest, but the algae savings can be real.
    • Keep the tank out of direct sunlight. Merck says to locate a tank away from direct sun, which limits algae, and that sun can also push the water temperature up, and warmer water holds less oxygen. A tank in the sun can fight your heater and your fish.
    • Place the tank on an inside wall. Away from windows, exterior doors and heating or cooling vents, the room temperature around the tank is steadier, so the heater cycles less. That's common sense rather than a measured result.
    • Use a lid or hood. PetMD's goldfish sheet says a tight-fitting lid keeps fish from escaping, and a cover also slows evaporation, which is common sense rather than a measured saving.
    • Watch the thermometer. Merck calls for a separate thermometer in the tank, so you can see whether the heater is doing its job rather than trusting its dial.
    Advertisement

    Costs that don't show up as wattage

    A bigger tank means more weight, and Merck says a gallon of water weighs 8.3 pounds, so a 55-gallon tank holds about 456 pounds of water. That's a stand and a floor matter, not an electricity one. Some costs also hide in running parts. Filter cartridges wear out, and Merck says hanging filters use a replaceable cartridge. Heaters and pumps can fail, and Merck says to ask whether your outlets are grounded and to consider a surge protector.

    Ponds raise the picture. A pump runs around the clock, and Merck says outdoor plugs should be grounded and waterproof. If you plan a pond, calculate the pump's wattage the same way.

    Tools to find your real numbers

    • Read the label on each device and write down the watts.
    • Read your last bill to find the kilowatt-hour price.
    • If your utility has time-of-use rates, check whether they apply to your plan. The Energy Information Administration notes that some utilities charge different prices at different times of day. Heaters run when they run, so this won't change much, but lights can be set to run in cheap hours.
    • If you're on a tight budget, ask your utility about assistance programs, and dial 211 for local help with utility bills if the household is behind. This is the same advice for any household bill, not just a fish tank.

    A budget check before you buy

    Run the math before you pick a species, not after. Say a 100-watt heater runs about half the time in your house: that's $6.23 a month, or about $75 a year. Compare that with a goldfish in a room-temperature tank at $1.66 a month. The initial purchase price of the fish is rarely the biggest cost. The tank, heater and electricity are.

    If the numbers are tight, the answer isn't to skip the heater on a tropical fish. A fish that's too cold gets sick, and treating disease costs more than power. The answer is to choose a species that fits the room, a smaller tank, or both. Better to find out that a tank doesn't fit the budget before you bring home an animal than after.

    This is general information. Watts and rates differ, so use your own device labels and your own bill for the final figure.

    Key sources: U.S. Energy Information Administration; Merck Veterinary Manual; University of Illinois College of Veterinary Medicine

Add your reply

Your email is never shown. Be kind โ€” you might be talking to a worried owner.